HoverBots1.1.4 - App Store
You'll be able to see results in few seconds.
Official App Store Link
We do not host HoverBots on our servers. We did not scan it for viruses, adware, spyware or other type of malware. This app is hosted by Apple and passed their terms and conditions to be listed there. We recommend caution when installing it.
The App Store link for HoverBots is provided to you by soft112.com without any warranties, representations or guarantees of any kind, so access it at your own risk.
If you have questions regarding this particular app contact the publisher directly. For questions about the functionalities of soft112.com contact us.
Publisher Description
ABOUT ROBOTICS: SMART MACHINES - HOVERBOTS
The HoverBots kit allows you to build and program six amazing robots that balance on two wheels! With this app installed on a supported Bluetooth-enabled device, you can remotely control, program, and adjust the balance settings of your robots.
HOW TO USE:
Position the balancing robot model with its wheels on a smooth floor in an open area.
Turn on the switch and hold the model upright with its weight on the floor until you feel its motors turning. Then the model will start balancing on its own.
Open the app on your device.
Establish a Bluetooth connection between the app and the robotic base unit.
There are three different modes: Remote Control, Balance Settings, and Programming. Refer to the product manual for more details.
*****
Questions or suggestions for improvements:
Mail to apps@kosmos.de
We are looking forward to your feedback!
*****
Version History - GUI fine-tune on Remote Control, Balancing Settings and Programming Mode.
- PID parameters will be downloaded to the chassis when leaving Balancing Settings
- Safety mechanisms for some unreasonable conditions of program blocks in Programming Mode. 1.1.4 12/12/2019 GUI improvement on Programming Mode 1.1.2 11/19/2019 What's new :
- Bugfix on the issue of balancing crash in Balancing-Robot Programming Mode
- Bugfix on the blank program-block at the runtime in Gyroscope-sensor Programming Mode
- Bugfix on the audio delay/repeat in programming modes 1.1.1 11/13/2019 - GUI improvement on the font size
- Improvement on the security
- Improvement on the compatibility on audio-playback
- Improvement on the performance of PID parameter library page switching
- Improvement on the model program management
- Bugfix on model program running
- Bugfix on the GUI of Programming Mode and RC Mode 1.0.8 10/21/2019 1.0.5 10/02/2019